t-case center output
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
t-case center output
i'm going to go with different rearends on my 63' m37 .the rear differential will be pretty much centered and it looks like you can use the center output on the t-case to drive the rearend.has anyone done this conversion? can it be done and what parts would i need? i would appreciate any and all input.thanks!!
-
- MSGT
- Posts: 828
- Joined: Sun Nov 15, 2009 11:50 am
- Location: Prince George BC Canada
- Contact:
Re: t-case center output
I've been led to belive that an output yoke from an M35 (Duece?) will work. Also there is a spacer ring that has been used to accomodate the two different bolt patterns between the park brake flange and drive shaft flange. Lastly there was some mention of the flanges and yokes being interchangeable between the stock NP200 and a regular NP205. I haven't tried this yet, but that would probably be the cheapest option.
Ray
1953 CDN. M37
1954 CDN. M152
1953 CDN. M37
1954 CDN. M152
Re: t-case center output
i've had someone tell me that you can use the center output flange off of a wc-62 6x6.before i buy any parts i was hoping someone could confirm what exactly is needed.thanks for your response!
- Paul in Kempner, TX
- PFC
- Posts: 89
- Joined: Sat Oct 20, 2007 7:07 am
- Location: Kempner, TX
- Contact:
M56 t-case center output
The Contact Truck M56 uses the center t-case output to drive the welder/generator. Everything you need is there. I haven't measured to see if the driveshaft needs its length changed, but it looks like it is okay as is.
Paul Cook at the Kempner Power Wagon Museum MVPA#27246
"You have to GO BUY the book before you can GO BY the book."
"You have to GO BUY the book before you can GO BY the book."
-
- PVT
- Posts: 49
- Joined: Sun Dec 16, 2007 7:24 am
- Location: North Lake, WI
Re: t-case center output
Yes, the center output flange off the WC62 will work on the M37 transfer case. It uses the small Detroit U joint like the civilian PW and the M37.firequad wrote:i've had someone tell me that you can use the center output flange off of a wc-62 6x6.before i buy any parts i was hoping someone could confirm what exactly is needed.thanks for your response!
Frank
Re: t-case center output
okay guys,thank you for the info.i guess i'll try vintage power wagons for parts.
-
- MSGT
- Posts: 828
- Joined: Sun Nov 15, 2009 11:50 am
- Location: Prince George BC Canada
- Contact:
Re: t-case center output
Frank Irons wrote:Yes, the center output flange off the WC62 will work on the M37 transfer case. It uses the small Detroit U joint like the civilian PW and the M37.firequad wrote:i've had someone tell me that you can use the center output flange off of a wc-62 6x6.before i buy any parts i was hoping someone could confirm what exactly is needed.thanks for your response!
Frank
Thats what I was thinking of - the WC62 - thanks for the correction guys...
Ray
1953 CDN. M37
1954 CDN. M152
1953 CDN. M37
1954 CDN. M152