Carburetor Stud Size & Distance on Manifold??

Rdinatal · Post by **Rdinatal** » Thu Jan 16, 2025 11:45 am

Can anyone measure, or know, the stud size and distance apart (not center to center) for the carburetor mounting??

Post by **Cal_Gary** » Sat Jan 18, 2025 12:31 am

Hi RD,
According to my TM9- 8030, the carb stud size is 3/8x16 NC x 24NF x 1 7/16 length.

Still digging on the distances; might anyone have a carb gasket they can measure for RD? My manuals don't have that measurement.
Thanks,
Gary

Rdinatal · Post by **Rdinatal** » Sat Jan 18, 2025 4:27 am

Cal_Gary wrote: ↑Sat Jan 18, 2025 12:31 am Hi RD,
According to my TM9- 8030, the carb stud size is 3/8x16 NC x 24NF x 1 7/16 length.

Still digging on the distances; might anyone have a carb gasket they can measure for RD? My manuals don't have that measurement.
Thanks,
Gary

Perfect! I have a gasket arriving tonight that will work for any other measurements.

Post by **Cal_Gary** » Sun Jan 19, 2025 10:21 pm

Excellent!

Blue Chips · Post by **Blue Chips** » Mon Jan 20, 2025 10:50 am

Rdinatal wrote: ↑Thu Jan 16, 2025 11:45 am Can anyone measure, or know, the stud size and distance apart (not center to center) for the carburetor mounting??

You might not need this information if you already have a gasket coming, but here's a photo of the manifold with measurements between the studs as well as center-to-center, which should be quite close. Please double-check them against the gasket you receive in case I made an error.

: carburetor-to-manifold-stud-measurements-smaller-image.jpg (236.65 KiB) Viewed 11 times

Carburetor Stud Size & Distance on Manifold??

Carburetor Stud Size & Distance on Manifold??

Re: Carburetor Stud Size & Distance on Manifold??

Re: Carburetor Stud Size & Distance on Manifold??

Re: Carburetor Stud Size & Distance on Manifold??

Re: Carburetor Stud Size & Distance on Manifold??