tool box floor questions

[06boblee]

DSC01576 (Small).JPG (88.9 KiB) Viewed 1050 times

DSC01575 (Small).JPG (87.34 KiB) Viewed 1050 times

DSC01574 (Small).JPG (93.09 KiB) Viewed 1050 times

I am putting the tool box floor on, and have run into a "thing". looking at the pics, you can see that the center section is about 3/16" lower (pics are of it upside down) than the outer portions. When I took this apart, the floor was totally rusted out- I found a replacement. All this happened years ago so I do not remember if there was something there to take up the gap. Anyone know?

[greeno]

Looks about right. When you add the strip caulk and tighten down the bolts there will be no issue.

[greeno]

17B1E700-C032-40A0-B91A-5676D18EE8F3.jpeg (104.75 KiB) Viewed 1032 times

Tough to see but my tabs were offset too.

[06boblee]

DSC01580 (Small).JPG (96.29 KiB) Viewed 1017 times

DSC01579 (Small).JPG (92.99 KiB) Viewed 1017 times

Thanks,
I found some 1"x1/8" bar stock laying around the shop, and made a couple of fillers. Painted them, seam sealed them and everything fit great.

[greeno]

Did you bolt the toolbox to the frame? I think you want them divorced for flexing.

[06boblee]

DSC01581 (Small).JPG (104.79 KiB) Viewed 1001 times

Did you bolt the toolbox to the frame? I think you want them divorced for flexing.

No, it just looks that way in the pic- attached to the crossmembers (for the bed)

[greeno]

Indeed! I'm getting old...

What paint color and brand are you using?

[06boblee]

Indeed! I'm getting old...

What paint color and brand are you using?

24087, I have bought 5 gallons of the stuff from the same vender on ebay, every time I get it it comes from a different paint co. The colors varied slightly from company to the next. So, I poured all of it into a 5 gallon bucket, mixed well and poured it back into the gallon paint can- now they are all the same color,

[sturmtyger380]

So, I poured all of it into a 5 gallon bucket

That's what happened I am sure during WWII and probably after for Army vehicle colors. Everyone gets all hung up on what color is correct, while Ford was recycling used but not sprayed paint on their assembly line. Just dump it all together and spray for the next production run. Not to mention what happened in the motor pool once the truck / jeep was in the field.

[vit16]

So beautiful peace of machinery!!

[06boblee]

DSC00744 (Small).JPG (129.15 KiB) Viewed 952 times

Just for fun, here is the "before" pic. had to replace the floor and both rails.

[m-37Bruce]

Mine was bad, but not that far gone!