g741.org

I have a T-245 engine for sale. This engine had less than 20 miles on it after a fresh rebuild when it spun a rod bearing. The cylinders still have the hone mark on them. Cylinders are bored .030 over. New valves and guides, new camshaft and bearings, timing chain and both sprockets are new. I have not taken the crankshaft out of this, but its safe to say it will need new rod bearings and the journals turned again. Not sure about the mains. Oil pressure always ran 45+ even with the bad bearing. It also includes a new heavy duty clutch pressure plate and disc. Also includes the engine stand as seen in the photos. No manifolds, distributor or carb.

https://www.dropbox.com/s/r9lcioge39nbp ... 1.JPG?dl=0
https://www.dropbox.com/s/m7k3yep5s79ul ... 2.JPG?dl=0
https://www.dropbox.com/s/4qyy69iggmwro ... 3.JPG?dl=0

Located in Matthews NC. Price $500 OBO Contact me via PM if interested. Thanks.

New Price....$400 PLUS exhaust and intake manifolds included.

I would be interested in the engine.

PM sent. Thanks.

Can you tell me if this engine is still available? I tried to send a PM but it said "user does not exist".

Thanks,
Mark

YIKES!! I hope I still exist...I'm not THAT old.

I'm sorry, it's been sold and being picked up this weekend. PM sent to you.

Thanks!

Jeff

Your profile is intact-no worries....
Gary

Jeff,
No worries, I was screwing it up. . lol I haven't been on the forum a lot in some time and just didn't do it correctly. Sorry I missed the.engine.
Mark