Page 1 of 1
Clutch shaft & bearing anyone?
Posted: Wed May 15, 2013 2:55 pm
by jim lee
The shaft that goes through the bell housing that pushes the throwout bearing in and out. I wasn't thinking and tossed it in the bin of parts that was to get sand blasted. And it got sand blasted. The bearing surface is.. Blasted. I figured it would be easier to just buy another one than try to resurface the old one.
So, anyone have an extra one of these?
Thanks!
-jim lee
Re: Clutch shaft & bearing anyone?
Posted: Wed May 15, 2013 4:35 pm
by T. Highway
Jim Lee,
I would call John @ Midwest Military or VPW.
Bert
Re: Clutch shaft & bearing anyone?
Posted: Wed May 15, 2013 7:55 pm
by Oddball-CmK
The clutch release fork? If so, I have a NOS one, if not disregard.
Which part letter(s) in the below diagrams (diagrams borrowed from Surplusjeep.com)?:
http://www.surplusjeep.com/M37/Images/02-1.jpg
http://www.surplusjeep.com/M37/Images/02-2.jpg
Re: Clutch shaft & bearing anyone?
Posted: Wed May 15, 2013 9:57 pm
by jim lee
p, l, j, k... Mostly k I'm looking for.
Great picture. I should have thought of that.
-jim lee
Re: Clutch shaft & bearing anyone?
Posted: Wed May 15, 2013 10:34 pm
by Oddball-CmK
In the first diagram? If so, I have that NOS:
Top of picture...
If you're interested, how does $42.50 sound (plus shipping from 06255).
Cordell
Re: Clutch shaft & bearing anyone?
Posted: Thu May 16, 2013 7:37 pm
by jim lee
Sounds fine. PM me your address and I can send you a check.
-jim lee
