Rotisserie for "non M37" work....
Posted: Mon Nov 01, 2010 7:10 am
Any of you guys have any experience with one of these military rotisseries? They have a 2600lb capacity and were normally used for big engine work. I got one cheap and am going to use it for restoring a jeep..err...non M37 vehicle.
The gearbox is stuck and I need to get that big gear off the main shaft. Any suggestions? I tried a cheap gear puller and I ended up with a broken puller. Maybe get a good heavy duty one?
I am soaking the two gears (worm and regular gear) in penetrant. I can't find any roll pins on the big gear so it should just be pressed on. I'll have to get a pic of the inside of the box.
Any ideas?
The gearbox is stuck and I need to get that big gear off the main shaft. Any suggestions? I tried a cheap gear puller and I ended up with a broken puller. Maybe get a good heavy duty one?
I am soaking the two gears (worm and regular gear) in penetrant. I can't find any roll pins on the big gear so it should just be pressed on. I'll have to get a pic of the inside of the box.
Any ideas?
