g741.org

I've been getting a little work done, and not have the underfloor reinforcements done, and now have to ties to the windshield fab'ed and tacked. Now to weld them and fit and weld in the final four bar reinforcements.




http://m37.wawii.com/

Looks like it will work Will? What type of windshield wiper are you planning on using

Whats a windshield wiper?

Actually, I'm still hoping someone comes up with a good 12 volt option. I have the vacuum units, but based on the results of the ones I had re-built for the PW, I won't go that route. Do you have any recommendations?

Is what I'm going with. Cabell has 12 volt electronics, I don't remember the brand, but they are on his web page. The problem is they are enormous, & right in the line of sight.
Charles Talbert uses a 12 volt wiper, he might chime in?

i done the vacum ones but i like the electric ones i found years ago that i put on a old 57 jeep. there were a direct bolt on and 12 volt but im thinking that i seen some 24 volts one too

Hello friend, nice work you did there. Regarding the wipers, perhaps you could find something out of a back hoe or a buldozer. Those wipers are intented for single pieces of flat glass and as far as I know some are available in 12 V. I do vote for electric over vacum however.

Hey Will,
Can give me some help/advice, how do I post a picture? Tried a few w/no luck so far? [/img][/url]

We can't post pictures on the new forum (yet). Robi is working on getting it set up so that we can, though. Hang in there...it will come.

I hope to re-install it tomorrow night.

The Bar is installed, what do you think, should I have painted it Green?



http://m37.wawii.com/

To paint it green, live with it a while, it could grow on us?
BTW, Did you get the wiper pix?