Arrggg...brakes
Posted: Fri Sep 12, 2008 3:15 pm
So I'm putting the passenger side rear ones on and I *just* notice there is a rubber gasket or buffer behind the washers, behind the two clips which hold the brakes shoes at the bottom.
Of course, when I went to degrease them for reassembly, they fell apart. I know I shoulda done this four months ago but....oh well.
Can I use gasket compound material to create these or am I stuck again for another week or so while I wait for parts?
Oh, and I just discovered my torque wrench is busted so I can't tell when I get to 100ft-lbs of torque on the bearing nuts. Crap, crap.....
Of course, when I went to degrease them for reassembly, they fell apart. I know I shoulda done this four months ago but....oh well.
Can I use gasket compound material to create these or am I stuck again for another week or so while I wait for parts?
Oh, and I just discovered my torque wrench is busted so I can't tell when I get to 100ft-lbs of torque on the bearing nuts. Crap, crap.....