Hi Guys,
I assembled the cowl vent yesterday. When I close it, it centers nicely in the hole and bears great in the back but the front is 1/2" up. I have the link bar at the extreme of the adjustment length so should have the most pull down. I have played the the adjustment of the hinge as well but can not effect the tilt of it to lay down flat. What am I missing here? It would seem to get the vent where it needs to be I would need to slot the holes more but that seems extreme, I have to figure it worked when I took it apart!
I appreciate any input!
Tim
Cowl vent question
Moderators: Cal_Gary, T. Highway, Monkey Man, robi
-
- SFC
- Posts: 744
- Joined: Thu Dec 18, 2008 4:49 pm
- Location: Monkton, Vermont
- Contact:
Cowl vent question
Happiness is enjoying what you already have!
Re: Cowl vent question
keep fighting they are a pain. got one on my fist try another sits flat when closed but wont raise all the way and a third one moves its full range but sits crooked when closed .... got hours into it
.............................. use it ...............
Re: Cowl vent question
mine had wear and elongation of the hole where the pivot pin was, so used a larger bolt to take up the slack. NV
Re: Cowl vent question
Yep, one of the M37's little 'time requirement' things.
It will behave, eventually.
PoW
It will behave, eventually.
PoW