The local Napa said he can fab one up if he has the right end fittings.
Meanwhile, this afternoon I found them on John's site. Probably order them with some other parts.
Thanks.
Search found 211 matches
- Thu Apr 18, 2024 10:26 am
- Forum: Technical group
- Topic: Fuel Shut Off to Pump Rubber Hose
- Replies: 3
- Views: 1991
- Thu Apr 18, 2024 5:18 am
- Forum: Technical group
- Topic: Fuel Shut Off to Pump Rubber Hose
- Replies: 3
- Views: 1991
Fuel Shut Off to Pump Rubber Hose
Greetings all, I need to replace the rubber hose between the shut off and stock fuel pump. Napa says they can't get the WH11089 hose anymore and none of the distributors listed on the Weatherhead by Danfloss are anywhere near me. Anyone know of a cross-reference/alternate hose or source that'll work...
- Sun May 15, 2022 9:53 am
- Forum: General M37
- Topic: Oil filter cover gasket
- Replies: 5
- Views: 706
Re: Oil filter cover gasket
Sal, Thanks. I'm pretty sure that is the one. So, here's what happened....back when I got my truck, it had a non-drain filter housing. Some years later, I found a Purolator filter body that had the drain. I swapped the lids rather than the entire assemblies because the non-drain housing had A/C deca...
- Sun May 15, 2022 4:50 am
- Forum: General M37
- Topic: Oil filter cover gasket
- Replies: 5
- Views: 706
Re: Oil filter cover gasket
Hal, Thanks for the info. No, this is coming from the lid gasket. I snug the lid down a bit. I've found in the past, if I don't snug the lid down, it leaks. I've never had a problem with the heavier, fiber-like gaskets but I haven't seen any of those in years, at least not with the NAPA ones I've be...
- Sat May 14, 2022 4:37 pm
- Forum: General M37
- Topic: Oil filter cover gasket
- Replies: 5
- Views: 706
Oil filter cover gasket
Hey, anyone know if any of the brands still come with the thick fiber-like gasket instead of the flimsy rubber gasket like the NAPA filters? Each year, at least the past few years, I have to finesse the gasket/lid into position so I don't get a leak. This year, I've worked with that gasket for 3 day...
- Sat May 14, 2022 4:34 pm
- Forum: General M37
- Topic: Dealing with leaking windshield bottom gasket
- Replies: 2
- Views: 511
Re: Dealing with leaking windshield bottom gasket
A little late but I use some of the foam rope sealer/caulk that you find in the store for drafts. It comes in different diameters so depending on the gap, you can find something that works. I started with the smallest diameter and worked my way up until it stopped the seepage. I just put the water h...
- Mon May 24, 2021 6:04 pm
- Forum: General M37
- Topic: 2021 ROLL CALL-PLEASE CHECK IN!
- Replies: 69
- Views: 26068
Re: 2021 ROLL CALL-PLEASE CHECK IN!
Mike L checking in from Indiana.
- Fri May 08, 2020 4:24 am
- Forum: General M37
- Topic: Origonal carb color
- Replies: 2
- Views: 690
Re: Origonal carb color
I believe the consensus is that originally they were factory colors of whatever was the industry standard at the time. Once the truck went into depo or overhaul, everything got a paint coat of OD. Fresh out of the factory, the carb would be plated per Carter specs and the engine the silver-gray that...
- Thu May 07, 2020 3:19 pm
- Forum: General M37
- Topic: ROLL CALL-WHERE IS EVERYONE?
- Replies: 88
- Views: 17245
Re: ROLL CALL-WHERE IS EVERYONE?
Hey Bruce.
Yep, we're doing well so far. How are you guys doing? How's the M37 project?
My truck is ready for the season. Just waiting for the season to start.
Yep, we're doing well so far. How are you guys doing? How's the M37 project?
My truck is ready for the season. Just waiting for the season to start.
- Wed May 06, 2020 5:12 pm
- Forum: Technical group
- Topic: Which Gauge Terminal to Sending Unit
- Replies: 5
- Views: 994
Re: Which Gauge Terminal to Sending Unit
On my gauge, when mounted in the dash, the outer connector (further from the speedometer) with the slots is the sender unit side. The inner connector (closer to the speedometer) is the spider connector and has the nubs/tabs inside. Or, if you have it in your hand, looking at the back, the connector ...
- Wed May 06, 2020 12:29 pm
- Forum: General M37
- Topic: ROLL CALL-WHERE IS EVERYONE?
- Replies: 88
- Views: 17245
Re: ROLL CALL-WHERE IS EVERYONE?
Haven't been on the site in a while. Still here though.
Hope all are well.
Hope all are well.
- Wed Jul 27, 2016 6:07 pm
- Forum: Technical group
- Topic: 1952 M37 turn signals and back brake lights
- Replies: 3
- Views: 1024
Re: 1952 M37 turn signals and back brake lights
This setup lets me use full brake and turn signal lights when I'm on the road. In a few minutes, I can stow them and it will look like a stock 1954 M37. A few minutes to set back up and I'm on the road again. OK, here is what the lights look like when mounted on the tailgate. There is a velcro strap...
- Wed Jul 27, 2016 5:42 pm
- Forum: Technical group
- Topic: Governor Adjustment Tool
- Replies: 3
- Views: 916
Re: Governor Adjustment Tool
One can be made from a deep socket and a thin flat-tip screwdriver. I used a 3/8" deep socket that I could fit a flat-tip screwdriver through the 1/4" drive end. I filed down about 1/32" from the socket end leaving two teeth to engage the governor's adjusting nut. The other end, the 1...
- Wed Jul 27, 2016 5:25 am
- Forum: Technical group
- Topic: 1952 M37 turn signals and back brake lights
- Replies: 3
- Views: 1024
Re: 1952 M37 turn signals and back brake lights
One inexpensive way is to take a trailer connecting cable and splice in a set of magnet-base trailer lights. When you drive the truck, you'll have signals and brake lights going down the road. When you show the truck, take the cable & lights off and the truck looks original. I have my T/S lever ...
- Mon Apr 11, 2016 11:45 am
- Forum: Technical group
- Topic: MWO or PS Magazine for tailgate center support bracket?
- Replies: 1
- Views: 497
Re: MWO or PS Magazine for tailgate center support bracket?
I don't have a copy but the MWO is G741-W10 3/4-ton, 4 x 4, trucks M37 and M42; extension of tailgate hinge support, dtd 9 May 56. I don't think this was ever shown in a PS magazine that I can recall.